Accumulator – Ferrari F1
Accumulator – Ferrari F1

The accumulator is responsible to store the pressure of the hydraulic system for later access by the actuators. The bladder type accumulator has two cells: one cell storing the hydraulic fluid and one cell containing a gas to create counterpressure. Both cells are separated by a membrane. These accumulators have a certain life span and a common defect is that the gas leaks out of the cell, which causes the system to be unable to build up hydraulic pressure. In many of such cases, the pump appears to prime permanently.

We offer the brand new original Magneti Marelli spare part.

Please mind: for the Ferrari F355 you will need an extra union kit / adapter to install this accumulator, which is available separately in our store.

240,00 
Actuator Dust Cover – Ferrari F1
Actuator Dust Cover – Ferrari F1

This is a brand-new F1 gear actuator dust cover made of aircraft grade aluminium. The set also includes a new flat gasket. This upgrade part replaces the original dust cover, which is made of plastic and often breaks.

80,00 
Clutch Pressure Sensor – Ferrari F1
Clutch Pressure Sensor – Ferrari F1

The clutch pressure sensor provides a signal of the hydraulic pressure on the clutch engagement hydraulic line. This is a brand-new spare part.

90,00 
E-Diff Hydraulic Lines – Ferrari F430 F1
E-Diff Hydraulic Lines – Ferrari F430 F1

Complete set of new hydraulic lines for the E-Diff system with heat protection coating

690,00 
E-Diff Pressure Sensor – Ferrari F1
E-Diff Pressure Sensor – Ferrari F1

The E-Diff pressure sensor provides a signal of the hydraulic pressure at the electronic differential of the F430. This is a brand-new spare part.

90,00 
E-Diff Solenoid Valve – Ferrari F430 F1
E-Diff Solenoid Valve – Ferrari F430 F1

The E-Diff valve is a pressure-proportional solenoid valve and controls the vehicle’s electronic differential. A faulty valve can cause various transmission and differential warnings up to a total failure of the differential control.

390,00 
Hydraulic Lines – Ferrari F430 360 F1
Hydraulic Lines – Ferrari F430 360 F1

This is a complete set of brand-new hydraulic lines for Ferrari F430 and 360 F1 transmission. Including 5 hydraulic lines for EV1, EV2, EV3, EV4, EV5 and the hose for the oil return.

All lines are made in Germany and come with a black protection coating. In addition, a high-quality fiberglass sleeve protects the lines from heat and abrasion.

590,00 
Pentosin CHF 11S
Pentosin CHF 11S

Pentosin CHF 11S is a synthetic high performance hydraulic fluid for life-time application in modern vehicle aggregates. Pentosin CHF 11S is especially designed for hydraulics in the automotive industry with the highest technical requirements such as in: power steering, level control, shock absorber, hydro-pneumatic suspension, stability and traction control, hydraulics for convertible tops, central lock systems, etc.

It is suitable for all extreme conditions and guarantees full performance from -40 Degree Celsius to over 130 Degree Celsius system temperature.

Pentosin CHF 11S meets DIN 51 524T3 and ISO 7308 specification standards.

23,00 
PPV Solenoid Valve – Ferrari F1
PPV Solenoid Valve – Ferrari F1

The valve block / power unit of the Ferrari F1 system contains 6 solenoid valves.

  • EVF (QPV) – clutch engagement
  • EV1 (PPV) – gear engagement
  • EV2 (PPV) – gear engagement
  • EV3 (QPV) – gear selection
  • EV4 (QPV) – gear selection
  • EV5 (QPV) – gear selection

Photo for demonstration purpose only. The valve may come without sticker label. Depending from model and year of construction the numbers on the sticker label may vary. In case you are not sure if the part fits your car, please contact us before you buy.

190,00 
Pressure Relief Valve – Ferrari F1
Pressure Relief Valve – Ferrari F1

The pressure relief valve is responsible to prevent damage to other components due to excess pressure in the hydraulic system. A defective valve would cause pressure loss and frequent pump cycles (similar symptoms as a worn pressure accumulator).

70,00 
Pressure Sensor – Ferrari F1
Pressure Sensor – Ferrari F1

The pressure sensor is responsible to detect the hydraulic pressure in the accumulator of the F1 system. This is an original and brandnew spare part.

80,00 
Pump Motor – Ferrari F1
Pump Motor – Ferrari F1

The pump motor drives the gear pump, which generates the pressure for the F1 transmission. Both parts together form the hydraulic pump. Without hydraulic pressure, the transmission cannot perform any action – neither change gears, nor operate the clutch. Therefore, the hydraulic pump is the most important component in the system.

In most cases, it is sufficient to replace only the electric motor, as this is a wearing part. The gear pump fails only very rarely. Another advantage is that when only the pump motor is changed, the hydraulic system does not need to be bled afterwards, unless it has been opened.

We sell an original, brand new Magneti Marelli spare part – the same part you would get from Ferrari.

Please check the car reference and compare the picture with your part. There are two types of Ferrari F1 pump motors.

270,00 
Pump Motor – Ferrari F1 (updated version)
Pump Motor – Ferrari F1 (updated version)

The pump motor drives the gear pump, which generates the pressure for the F1 transmission. Both parts together form the hydraulic pump. Without hydraulic pressure, the transmission cannot perform any action – neither change gears, nor operate the clutch. Therefore, the hydraulic pump is the most important component in the system.

In most cases, it is sufficient to replace only the electric motor, as this is a wearing part. The gear pump fails only very rarely. Another advantage is that when only the pump motor is changed, the hydraulic system does not need to be bled afterwards, unless it has been opened.

We sell an original, brand new Magneti Marelli spare part – the same part you would get from Ferrari.

Please check the car reference and compare the picture with your part. There are two types of Ferrari F1 pump motors.

270,00 
Pump Relay – Ferrari F1 (4-pin)
Pump Relay – Ferrari F1 (4-pin)

The electromagnetic relay is responsible to turn on / off the hydraulic pump of the Ferrari F1 system. A broken relay causes the pump to fail priming. Without hydraulic pressure, the system cannot engage the gears or clutch.


Please mind, that there are two different versions for the Ferrari F1 relay (30A with 5 pins and 50A with 4 pins). Check the car reference and compare the part numbers.

25,00 
QPV Solenoid Valve – Ferrari F1
QPV Solenoid Valve – Ferrari F1

The valve block / power unit of the Ferrari F1 system contains 6 solenoid valves.

  • EVF (QPV) – clutch engagement
  • EV1 (PPV) – gear engagement
  • EV2 (PPV) – gear engagement
  • EV3 (QPV) – gear selection
  • EV4 (QPV) – gear selection
  • EV5 (QPV) – gear selection

Please note: The product photo is for illustrative purposes only. The valve may be supplied without a sticker label. Depending from model and year of construction the numbers on the sticker label of your original valve may vary. The valve supplied by us replaces QPV02 and QPV10 valves, but not QPV14. In case you are not sure if our part fits, please contact us before you buy.

180,00 
Service Kit Hydraulic Pump – Ferrari F1 (updated version)
Service Kit Hydraulic Pump – Ferrari F1 (updated version)

The service kit includes the plastic coupling, which connects the shaft of the gear pump with the shaft of the electric motor, as well as seals. This set is for the “new” type F1 pump.

18,00