EV0 Clutch Solenoid Valve – Fiat Dualogic / Selespeed
The EV0 Solenoid Valve is responsible for the clutch actuation of the Selespeed system. A faulty EV0 can cause problems while engaging the clutch (for example shuttering) and in consequence the car refuses to change gears.
We sell an original Magneti Marelli spare part. Depending from model and year of construction the numbers on the sticker label may vary. In case you are not sure if the part fits your car, please contact us before you buy.
EV1 / EV2 Engagement Solenoid Valve – Fiat Dualogic / Selespeed
The Engagement Solenoid Valves are responsible to engage the gears of the Dualogic / Selespeed system. In the case of failure of this valve, the car will refuse to go into one or more gears.
EV3 / EV4 Selection Solenoid Valve – Fiat Dualogic / Selespeed
The Selection Solenoid Valves are responsible for selecting the gears of the Dualogic / Selespeed system. In the case of failure of this valve, the car will refuse to go into one or more gears.
Pressure sensor – Fiat Dualogic / Selespeed
The pressure sensor is responsible to detect the hydraulic pressure in the accumulator of the Dualogic / Selespeed system. This is an original and brandnew spare part.
Pump motor – Fiat Dualogic / Selespeed
The pump motor drives the gear pump, which generates the pressure for the Dualogic / Selespeed transmission. Both parts together form the hydraulic pump. Without hydraulic pressure, the transmission cannot perform any action – neither change gears, nor operate the clutch. Therefore, the hydraulic pump is the most important component in the system.
In most cases, it is sufficient to replace only the electric motor, as this is a wearing part. The gear pump fails only very rarely. Another advantage is that when only the pump motor is changed, the hydraulic system does not need to be bled afterwards, unless it has been opened.
We sell an original, brand new Magneti Marelli spare part – the same part you would get from Fiat.
Selection / Clutch Sensor – Fiat Dualogic / Selespeed
The Dualogic / Selespeed selection and engagement position sensors (Potentiometers) are responsible to detect the current state of the gear engagement. The clutch sensor is responsible to detect the state of the clutch. There are three of these sensors installed on the Dualogic / Selespeed unit. A faulty sensor can prevent the car to engage gears or shift.
We sell an original spare part from Magneti Marelli.