Accumulator – Dodge Dart DDCT
The accumulator is responsible to store the pressure of the hydraulic system for later access by the actuators. The bladder type accumulator has two cells: one cell storing the hydraulic fluid and one cell containing a gas to create counterpressure. Both cells are separated by a membrane. These accumulators have a certain life span and a common defect is that the gas leaks out of the cell, which causes the system to be unable to build up hydraulic pressure. In many of such cases, the pump appears to prime permanently.
We offer a brand new original Magneti Marelli spare part.
Filter – Dodge Dart DDCT
The filter is located in front of the hydraulic pump’s fluid inlet and is responsible for removing contaminants from the hydraulic system, as these could otherwise cause damage to the various components. If the filter becomes clogged, the pump’s suction performance decreases, and the system may build pressure more slowly or not at all. This is a brand new, original Magneti Marelli spare part.
Gear Position & Clutch Speed Sensor Module – Dodge Dart DDCT
The integrated sensor module monitors gear engagement positions and clutch rotational speeds in the Dodge Dart DDCT dual-clutch transmission. It incorporates four magnetoresistive position sensors to detect the engagement of the six forward gears and reverse gear, as well as two speed sensors monitoring the rotational speeds of clutches K1 and K2. The module also carries the temperature signal from the hydraulic actuator assembly to the transmission control unit. Faulty sensors can cause incorrect gear position readings, shifting problems, transmission error messages or emergency operating mode.
We offer a used, cleaned and tested original component.
Hydraulic Actuation Module – Dodge Dart DDCT
The hydraulic actuation module controls clutch operation, gear selection and gear engagement in the Dodge Dart DDCT dual-clutch transmission. It contains six proportional solenoid valves that regulate hydraulic pressure and oil flow for the two clutches and the gear shifting mechanisms. Integrated pressure and position sensors monitor hydraulic pressure and actuator movements, allowing the transmission control unit to precisely manage clutch engagement and gear changes. A defective module can cause shifting problems, clutch engagement failures, transmission error messages or emergency operating mode.
We supply refurbished original units that have been cleaned and tested.
Pressure Sensor – Dodge Dart DDCT
The pressure sensor is responsible to detect the hydraulic pressure in the accumulator of the Dodge Dart Dual Dry Clutch system. This is an original and brandnew spare part.
Pump Motor – Dodge Dart DDCT
New Dodge Dart DDCT pump motor
- Original Magneti Marelli spare part
- High quality
- 12-month warranty included
The pump supplies the hydraulic pressure for the different consumers (actuators) of the Dodge Dart DDCT system and stores it in the pressure accumulator. The pump consists of a small gear pump and an electric motor. If the pump motor fails, the DDCT cannot perform clutch operations or gear changes due to the lack of pressure.